Type 2600 Safety Relief Valve

The Type 2600 Relief/Safety Relief valves are designed to have a short simmer, then to open rapidly to the full open position, and to re-seat at a controlled pressure. When the valve is in its fully lifted position, the discharge area is controlled by the bore of the nozzle, which ensures that flow calculations for various mediums can be reliably made. Valves are supplied in sizes half inch to one inch and can be manufactured in Gunmetal, Cast Steel and Stainless Steel with ends screwed male x female, female x female or flanged to customers requirements.

Valves can also be supplied with a packed lever lifting device, limit switch to indicate opening and closing of the valve, governing ring to limit adjustment of the spring to the set point, for ease of re-setting.

Contact Sales for more information.

During installation of the valve avoid bumping or shaking to prevent damaging the flange faces and misalignment of the trim. Blow through the circuit line on which the valve is to be installed, this is to
remove any foreign bodies. Clean the valve and nozzle connections thoroughly; foreign bodies on the nozzle may damage the valve seat during popping. Install the valve in a vertical position only, with
the inlet downwards. After the valve has been installed make it pop at least twice to allow automatic alignment of the trim. Misalignment may be caused accidentally during transport or during installation.

Type_2600.pdf

SD23-NL-2600-SRV.xls
SD23-ES-2600-SRV.xls
SD23-Rus-2600-SRV.xls